MULTIPLE CHOICE QUESTIONS

1		A section view usually shows __________ details.
			A)	exterior
			B)	interior
			C)	profile
			D)	foreshortened
2		What are the lines in a section view used to show where the material is cut called?
			A)	cutting plane lines
			B)	section lines
			C)	object lines
			D)	hidden lines
3		When are ribs sectioned?
			A)	When they are perpendicular to the cutting plane
			B)	When they are parallel to the cutting plane
			C)	Ribs are always sectioned
			D)	Ribs are never sectioned
4		When a quarter of the object is removed, the section is a:
			A)	full section
			B)	half section
			C)	quarter section
			D)	eighth section
5		The direction of line of sight of a section is indicated by the:
			A)	viewing direction of the section
			B)	offset section in the section
			C)	arrows at the end of the cutting plane line
			D)	dashed lines on the section
6		A(n) __________ is a section view drawing in which the cutting plane is perpendicularly bent to pass through all important interior details.
			A)	full section
			B)	revolved section
			C)	offset section
			D)	broken-out section
7		A __________ section make use of a short break line.
			A)	whole
			B)	offset
			C)	revolved
			D)	broken-out
8		Cutting plane lines compared to object lines are:
			A)	lighter & thinner
			B)	darker & thinner
			C)	same darkness & thicker
			D)	same darkness & thinner
9		Section lines compared to object lines are:
			A)	lighter & thinner
			B)	darker & thinner
			C)	same darkness & thicker
			D)	same darkness & thinner
10		In an assembly section which of the following parts are not sectioned?
			A)	threaded fasteners
			B)	plastics
			C)	the smallest piece
			D)	the outer piece
11		In an assembly section a thin washer, gasket, or sheet metal is described by:
			A)	the cast iron crosshatching symbol.
			B)	not crosshatching it.
			C)	not showing it.
			D)	darkening it entirely black.
12		A section view that shows the section superimposed on a standard view is a:
			A)	auxiliary section
			B)	removed section
			C)	revolved section
			D)	offset section
13		A section is identified by use of:
			A)	a conventional break
			B)	a reference plane
			C)	a reference line
			D)	a cutting plane
14		When a cutting plane is located in a view:
			A)	all other views are shown with a segment removed
			B)	only the view where the cutting plane arrows is pointing is sectioned
			C)	an adjacent view is sectioned
			D)	none of the adjacent views are sectioned
15		A _________ is used mainly to expose small portions of the interior of an objects
			A)	revolved section
			B)	removed section
			C)	broken-out section
			D)	none of the above
16		A __________section is used when the section view will be placed in another drawing sheet.
			A)	revolved
			B)	removed
			C)	offset
			D)	phantom
17		The purpose of the arrowheads on a cutting plane line is to:
			A)	show the direction in which the imaginary cut surface is viewed
			B)	indicate the location of the cutting plane
			C)	identify the reference letters such as section A-A or B-B, etc.
			D)	all of the above