Diagnosing and Repairing Accessory and Safety Systems



1.	When handling an electronic module, electrostatic discharge:
	A.	Should be avoided through careful handling.
	B.	Can cause permanent component damage.
	C.	Can cause accidental shorting of circuits.
	D.	All of the above.

2.	What is the risk in energizing the servo solenoid valves with jumper wires while the engine is running?
	A.	Engine over-speed may cause severe engine damage.
	B.	Electrostatic discharge may cause circuit shorting.
	C.	Throttle linkage may break.
	D.	None of the above.

3.	The air bag inflator module circuit should not be tested with an ohmmeter or test light.
	A.	True.
	B.	False.

4.	After the ignition is turned off, how long should you wait before working on the air bag system?
	A.	At least 5 minutes.
	B.	At least 10 minutes.
	C.	At least 20 minutes.
	D.	At least 30 minutes.

5.	After air bag deployment, how long should you wait before handling the air bag?
	A.	At least 5 minutes (or the time specified).
	B.	At least 10 minutes (or the time specified).
	C.	At least 20 minutes (or the time specified).
	D.	At least 30 minutes (or the time specified).

Log In

The resource you requested requires you to enter a username and password below: