Student CenterNoState
Teacher CenterNoState
GLENCOE.com Home > OLC
Online Learning Center
Trade & Industrial Education

Servicing the Block Assembly




1.If one cylinder requires machining, the other cylinders should be bored or honed to the same size.
True.
False.


2.Increasing a cylinder bore will:
Decrease compression in that cylinder.
Increase compression in that cylinder.
Have no effect on compression.
Cause the engine to run more smoothly


3.When installing cam bearings, you should:
Not lubricate the bearings before installation.
Lubricate the bearings before installation.
Make sure the bearings turn freely in their bores.
None of the above.


4.During combustion, which of the following may be caused by sharp edges on the piston?
Slick spots.
Sizzle spots.
Pock spots.
Hot spots.


5.If a ring is to be installed on the piston to measure side clearance, a piston expander should be used.
True.
False.

Log In

The resource you requested requires you to enter a username and password below:

Username:
Password: